LAN Problems with NDIS2 Drivers 57LAN Problems with NDIS2 DriversSymptom SolutionNo adapter detected. n LAN+Modem is not in the PCMCIA slot, or isnot being recognized by C&SS.Card services could not allocateLAN IRQ.n The value specified for Interrupt in thePROTOCOL.INI file is not available. Try usinganother address.n Use File/Edit Configuration to check that theLAN IRQ does not conflict with any IRQsalready in use. If so, change the IRQ setting(make the same change in PROTOCOL.INI).Card services could not allocateLAN I/O PORT base address.Bank select port failed torespond.n The I/O base-address value in thePROTOCOL.INI file is not available for use. Tryanother port address. Check that the baseaddress setting in Card and Socket Servicesmatches that in PROTOCOL.INI.Enabler cannot activate the card. n Try to make more resources available (BIOS).Enabler activates the card but itcannot see the server.n Try to force Enabler to use a different IRQ(possibly found by CONFIG), for example:FMENABLE IRQ=AWhere A is the hexadecimal value of 10.Enabler fails to find the card n Verify the EMM386.EXE settings inCONFIG.SYS.
