Running the Point Enabler Under DOS 33Follow these steps to exclude a sample 8 K memory range:1 Make a backup copy of the CONFIG.SYS file.2 Use a text editor to edit the CONFIG.SYS file on yourcomputer.3 Exclude the memory range that the LAN+Modem cardis using.For example, type this line in the CONFIG.SYS file:device=c:\windows\emm386.exe NOEMS x=DE00-DFFF(8k)where x stands for exclude, followed by an 8K contiguousblock of memory. In this example, the memory setting isDE00–DFFF.Refer to the manual that accompanied the memory managersoftware for additional instructions and information.4 Save the CONFIG.SYS file and exit the text editor.5 Reboot the computer.Running the Point Enabler Under DOSFor NetWare networking environments, the point enablershould be installed in the AUTOEXEC.BAT file. Make surethat the point enabler program, FMENABLE.EXE, is listedbefore the ODI driver. The AUTOEXEC.BAT file shouldcontain the line:fmenable.exeFor NDIS networking environments, the point enablershould be installed in the CONFIG.SYS file. Make sure thethat the point enabler program is listed before the NDISdriver. The CONFIG.SYS file should contain the line:device=c:\nwclient\fmenable.exeAlternatively, you can run the configuration managermanually from DOS each time you use the modem bytyping:fmenable [Enter]
