474 CHAPTER 41: BOOT ROM AND HOST S OFTWARE L OADINGFigure 161 Sending file pageStep 9: After the sending process completes, the system displays the followinginformation:Loading ...CCCCCCCCCC done!Step 10: Reset HyperTerminal’s baudrate to 9600 bps (refer to Step 4 and 5). Then,press any key as prompted. The system will display the following informationwhen it completes the loading.Bootrom updating.....................................done!n ■ If the HyperTerminal’s baudrate is not reset to 9600 bps, the system prompts"Your baudrate should be set to 9600 bps again! Press enter key when ready".■ You need not reset the HyperTerminal’s baudrate and can skip the last step ifyou have chosen 9600 bps. In this case, the system upgrades the Boot ROMautomatically and prompts "Bootrom updatingnow.....................................done!".Loading host softwareFollow these steps to load the host software:Step 1: Select <1> in BOOT Menu and press . The system displays thefollowing information:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):Step 2: Enter 3 in the above menu to load the host software by using XModem.
