506 CHAPTER 45: REMOTE -P ING CONFIGURATION7 Configuring TCP test on Remote-Ping clientConfigure the source IPaddresssource-ip ip-address OptionalBy default, no source IPaddress is configured.Configure the source port source-port port-number OptionalBy default, no source port isconfigured.Configure the test type test-type snmpquery RequiredBy default, the test type isICMP.Configure the number ofprobes per testcount times OptionalBy default, each test makesone probe.Configure the maximumnumber of history records thatcan be savedhistory-records number Figure 176 OptionalBy default, the maximumnumber is 50.Configure the automatic testintervalfrequency interval OptionalBy default, the automatic testinterval is zero seconds,indicating no automatic testwill be made.Configure the probe timeouttimetimeout time OptionalBy default, a probe times outin three seconds.Configure the type of service tos value OptionalBy default, the service type iszero.Start the test test-enable RequiredDisplay test results display Remote-Pingresults [ admin-nameoperation-tag ]RequiredYou can execute thecommand in any view.Table 377 Configure SNMP test on Remote-Ping clientOperation Command DescriptionTable 378 Configure TCP test on Remote-Ping clientOperation Command DescriptionEnter system view system-view -Enable the Remote-Ping clientfunctionRemote-Ping-agent enable RequiredBy default, the Remote-Pingclient function is disabled.Create a Remote-Ping testgroup and enter its viewRemote-Pingadministrator-nameoperation- tagRequiredBy default, no test group isconfigured.
