Remote-Ping Configuration Example 511Displaying Remote-Ping ConfigurationAfter the above-mentioned configuration, you can use the display commands toview the results of the latest test and history information.Remote-PingConfigurationExampleICMP Test Network requirementsThe Switch 4210 serves as the Remote-Ping client. A Remote-Ping ICMP testbetween the switch and another switch uses ICMP to test the round trip time (RTT)for packets generated by the Remote-Ping client to travel to and back from thedestination switch.Network diagramFigure 180 Network diagram for the ICMP testConfiguration procedure■ Configure Remote-Ping Client (Switch A):# Enable Remote-Ping client.<4210> system-view[4210] Remote-Ping-agent enable# Create a Remote-Ping test group, setting the administrator name to"administrator" and test tag to "ICMP".[4210] Remote-Ping administrator icmp# Configure the test type as icmp.Configure the number ofconsecutive unsuccessfulRemote-Ping probes beforeTrap outputprobe-failtimes times OptionalBy default, Trap messages aresent each time a probe fails.Table 382 Display Remote-Ping test resultsOperation Command DescriptionDisplay test history display Remote-Ping history [administrator-nameoperation-tag ]Available in any view.Display the results of thelatest testdisplay Remote-Ping results [administrator-nameoperation-tag ]Table 381 Configure the Remote-Ping client to send Trap messagesOperation Command DescriptionSwitch A Switch BHWPing ClientIP network10.1.1.1/8 10.2.2.2/8
