44 DEVICE MANAGEMENTDevice ManagementConfigurationDevice ManagementConfiguration TasksRebooting the EthernetSwitchYou can perform the following operation in user view when the switch is faulty orneeds to be rebooted.n Before rebooting, the system checks whether there is any configuration change. Ifyes, it prompts whether or not to proceed. This prevents the system from losingthe configurations in case of shutting down the system without saving theconfigurationsScheduling a Reboot onthe SwitchAfter you schedule a reboot on the switch, the switch will reboot at the specifiedtime.Table 361 Device management configuration tasksTask Remarks“Rebooting the Ethernet Switch” Optional“Scheduling a Reboot on the Switch” Optional“Configuring Real-time Monitoring of theRunning Status of the System”Optional“Specifying the APP to be Used at Reboot” Optional“Upgrading the Boot ROM” OptionalTable 362 Reboot the Ethernet switchOperation Command DescriptionReboot the Ethernet switch reboot [ unit unit-id ] Available in user viewTable 363 Schedule a reboot on the switchOperation Command DescriptionSchedule a reboot on theswitch, and set the rebootdate and timeschedule reboot at hh:mm [mm/dd/yyyy | yyyy/mm/dd ]OptionalSchedule a reboot on theswitch, and set the delay timefor rebootschedule reboot delay {hh:mm | mm }OptionalEnter system view system-view -Schedule a reboot on theswitch, and set the rebootperiodschedule reboot regularityat hh:mm periodOptional