540 CHAPTER 46: IPV 6 MANGEMENT CONFIGURATIONIPv6 ConfigurationExampleIPv6 Unicast AddressConfigurationNetwork requirementsTwo switches are directly connected through two Ethernet ports. The Ethernetports belong to VLAN 2. IPv6 addresses are configured for the interfaceVlan-interface2 on each switch to verify the connectivity between the twoswitches. The global unicast address of Switch A is 3001::1/64, and the globalunicast address of Switch B is 3001::2/64.Network diagramFigure 193 Network diagram for IPv6 address configurationConfiguration procedure1 Configure Switch A.# Configure an automatically generated link-local address for the interfaceVlan-interface2. system-view[SwitchA] interface Vlan-interface 2[SwitchA-Vlan-interface2] ipv6 address auto link-local# Configure a global unicast address for the interface Vlan-interface2.[SwitchA-Vlan-interface2] ipv6 address 3001::1/642 Configure Switch B.# Configure an automatically generated link-local address for the interfaceVlan-interface2. system-view[SwitchB] interface Vlan-interface 2[SwitchB-Vlan-interface2] ipv6 address auto link-local# Configure a global unicast address for the interface Vlan-interface2.[SwitchB-Vlan-interface2] ipv6 address 3001::2/64Verification# Display the brief IPv6 information of an interface on Switch A.[SwitchA-Vlan-interface2] display ipv6 interface vlan-interface 2Vlan-interface2 current state :UPLine protocol current state :UPIPv6 is enabled, link-local address is FE80::20F:E2FF:FE47:4CA3Global unicast address(es):3001::1, subnet is 3001::/64 [DUPLICATE]Switch A Switch BVlan-interface2Vlan-interface2
