Changing the Configuration 4-3Changing theConfigurationTo change the communications server configuration, follow thisprocedure:1 Enter the firmware configuration command fc at the monitor prompt.The following menu is displayed:2 Type D to display current parameter settings.The following display shows factory default settings for the CS/2600(except for Ethernet address, which is only an example):Default settngs for the CS/2500 are the same, except that Initial BootSource is “Network.”3 To return to the Firmware Configuration Utility menu, press the Returnkey.Firmware Configuration UtilityCommands:C - Change parametersD - Display parametersesc- Exit to monitorCurrent Parameters:Ethernet address 080002025DACConsole baud rate 9600Console port 0Continuous self-test DisabledAuto-reboot Reboot onlyMonitor DisabledInitial boot source Floppy then NetworkNumber of reboots 00Network boot string _cs200Boot retries Try ForeverBoot protocol SLPNumber of ports 10Default memory map CS/2500/2600RS-232 ports 0 1 2 3 4 5 6 7 8 9RS-422 portsAuto RS-422 select DisabledLF issued after CR YESPrinter setup string:CS2500BookFile : Configuration Page 3 Thursday, December 11, 1997 10:44 AM
