60 APPENDIX C: SAMPLE CONFIGURATION S CRIPTSserver to the network segment on which it will reside, this error shouldno longer appear.Starting ntpd: [ OK ]Stopping VCX-CommonAgent: [ OK ]Starting VCX-CommonAgent: [ OK ]Stopping httpd: [ OK ]Starting httpd: httpd: Could not determine the server's fully qualified domain name,using 10.230.143.24 for ServerNameOptionally, you can register this server’s name on your DNS server(s). Ifyou do, you can then use the hostname to access the server, rather thatthe IP address.[ OK ]At this point, the server is ready to be shut down and moved to thenetwork segment on which it will reside. To shut down the server, enterthe next command.shutdown nowReconfigurationSample ScriptThis script was run on a primary VCX Connect server in order to configurethe network parameters and additional configuration parameters. If yourun this script on a secondary VCX Connect server, the script questionsare identical, but your answers must be changed slightly for thesecondary server.To run this script, you must be logged in to the root account on theserver.Throughout the script sample, comments are provided immediately afterthe section of the script to which they apply. Comments appear in adifferent type face and are indented for easy identification.Default answers are enclosed in square brackets (for example, [yes]). Toaccept the default answer to any question/prompt, press the Enter orReturn key.To start the script, enter this command:vcx-reconfigure------------------------------------------------------------------------------------------ Welcome to the VCX Reconfiguration Utility -------------------------------------------------------------------------------------------This utility allows a previously configured VCX system to be reconfigured -for example, to change its IP address or the IP addresses of other VCX