ProJet® x60 Series User Guide Troubleshooting the ProJet x60 Printers3dscentral.3dsystems.com 58 All Rights Reserved5/12/137.8 Part Quality Issues Streaky/Striped Parts, Delamination, WeakPartsExplanation: In a color print job, streaky or striped parts are easy to identify (see photo below). Thestreaks or stripes are caused either by Core buildup on the print head, a failed print head, or an electricalissue within the printer. With a monochrome printer, this is harder to see, and in fact often shows up asweak parts, or parts that delaminate.Delamination (layers splitting apart) may be due to a print head that is caked with Core, or a pause in net-work communications.Solution - Both:• Clean the service station.• Ensure the printer has Cleaning Solution.• Clean the Fast Axis Rails of any debris and reboot the printer. See Section 3.3, ’Clean The FastAxis Rails and Carriage’.If the problem persists,• Clean the pogo pins and the print head contacts.Additional Solution - DelaminationCheck your PC settings. The printer may be pausing as it waits for additional data from the PC. Whilepausing, the printed part begins to dry and as a result the next layer does not stick to the last layer printed.Your PC should be dedicated to 3D Print. Your PC Power Management software should be completely shutoff.
