Chapter 2. CLI Syntax Reference127 3ware SAS/SATA RAID Controller CLI Guide, Version 9.5.2Example://localhost> /c0/e0 show fans---Speed---Fan Status State Step RPM Identify------------------------------------------------------------fan0 OK ON 1 2670 Offfan1 OK ON 1 9370 Offfan2 OK ON 1 8540 Offfan3 OK ON 1 2810 Offfan4 OK ON 1 9240 Offfan5 OK ON 1 8330 Off/cx/ex show tempThis command is used with the 9690SA controller. For the 9650SE, simplydrop the prepended controller name in the command and use /ex.This command lists the temperature sensors in enclosure /cx/ex and thecurrent temperature.Note: The maximum temperature for successful use of a drive should benoted in the documentation for the drive.The TempSensor column lists the temperature sensor IDs, the Status columnlists the status of each temperature sensor, the Temperature column shows thetemperature at the sensors, and the Identify column lists the Identify setting ofthe temperature sensorsExample://localhost> /c0/e0 show tempTempSensor Status Temperature Identify--------------------------------------------------------temp0 OK 41C(105F) Offtemp1 OK 37C(98F) Offtemp2 OK 34C(93F) Offtemp3 OK 38C(100F) Offtemp4 OK 38C(100F) Offtemp5 OK 34C(93F) Offtemp6 NOT-INSTALLED - Offtemp7 NOT-INSTALLED - Off/cx/ex show pwrsThis command is used with the 9690SA controller. For the 9650SE, simplydrop the prepended controller name in the command and use /ex.This command reports a summary of power supplies with their respectiveinformation for the specified enclosure.The PowerSupply column lists the IDs of the power supply units, the Statuscolumn lists the status of each power supply, the State column indicate if the
