EN – R0…R4 Quick installation guide 23R0-R4R5R6-R9ENDADEESFIFRITNLPLPTRUSVTRZHZHEN – R0…R4 Quick installation guideThis guide briefly describes how to install and start-up the drive. For completeinformation on installation, see ACS580-01 (0.75 to 250 kW) hardware manual(3AXD50000018826 [English]). For start-up instructions, see chapter EN – Quickstart-up guide on page 321.To read a manual, go to www.abb.com/drives/documents and search for thedocument number.Obey the safety instructionsCheck if capacitors need to be reformedIf the drive has not been powered (either in storage or unused) for over one year, youmust reform the capacitors.You can determine the manufacturing time from the serial number, which you find onthe type designation label attached to the drive. The serial number is of formatMYYWWRXXXX. YY and WW tell the manufacturing year and week as follows:YY: 13, 14, 15, … for 2013, 2014, 2015, …WW: 01, 02, 03, … for week 1, week 2, week 3, …For information on reforming the capacitors, see Converter module capacitorreforming instructions (3BFE64059629 [English]), available on the Internet atwww.abb.com/drives/documents.WARNING! Obey these instructions. If you ignore them, injury or death, ordamage to the equipment can occur:• If you are not a qualified electrician, do not do electrical installation work.• Do not work on the drive, motor cable or motor when main power is applied. Ifthe drive is already connected to the input power, wait for 5 minutes afterdisconnecting the input power.• Do not work on the control cables when power is applied to the drive or to theexternal control circuits.• Make sure that debris from borings and grindings does not enter the drive wheninstalling.• Make sure that the floor below the drive and the wall where the drive is installedare non-flammable.
