NoteActionBA CDxx1200001352Measure the oil level at the oil plug hole.Required oil level for IRB 2600-20/1.65, IRB2600-12/1.65, IRB 2600-12/1.85, IRB 2600ID-15/1.85, IRB 2600ID-8/2.0:• 10 mm ± 3 mm below the lower edgeof the oil plug inspection hole.Required oil level for IRB 2600 Type C-20/1.65, IRB 2600 Type C-12/1.65:• 12 mm ± 3 mm below the lower edgeof the oil plug inspection hole.5Parts:A Oil levelB Measurement of required oil levelC Oil plug hole inspectionD GearHow to fill oil is described in section:• Changing the oil, axis 1 gearbox onfloor mounted robots on page 150Add oil if required.6Tightening torque:• 24 NmRefit the oil plug, inspection.7Inspecting oil level, axis-1 gearbox (suspended robot)Use this procedure to inspect the oil level in the axis-1 gearbox for IRB 2600-20/1.65,IRB 2600-12/1.65, IRB 2600-12/1.85, IRB 2600ID-15/1.85, IRB 2600ID-8/2.0.IRB 2600 Type C-20/1.65, IRB 2600 Type C-12/1.65 is not available for suspendedinstallation.CAUTIONIf the robot has the earlier design of the frame, and the robot is filled with anamount of oil suited for an inverted position, the oil level of the axis-1 gearboxwill be above the oil plug hole when the robot is standing on the floor, which willresult in oil leakage if the plug is opened while robot stands on the floor! The oillevel of axis-1 gearbox can therefore only be inspected when the robot is mountedin an inverted position!NoteActionWARNINGHandling gearbox oil involves several safetyrisks. Before proceeding, please read thesafety information in the section Safety risksduring work with gearbox lubricants (oil orgrease) on page 39.1Continues on next page122 Product manual - IRB 26003HAC035504-001 Revision: Q© Copyright 2009-2018 ABB. All rights reserved.3 Maintenance3.3.1 Inspecting oil level, axis-1 gearboxContinued
