• the character ^ in front of an input/output signal name indicates that thesignal name may be customized using the PCM600 software.• the character * after an input signal name indicates that the signal mustbe connected to another function block in the application configurationto achieve a valid application configuration.• Logic diagrams describe the signal logic inside the function block and arebordered by dashed lines.• Signals in frames with a shaded area on their right hand side representsetting parameter signals that are only settable via the PST, ECT orLHMI.• If an internal signal path cannot be drawn with a continuous line, thesuffix -int is added to the signal name to indicate where the signal startsand continues.• Signal paths that extend beyond the logic diagram and continue inanother diagram have the suffix ”-cont.”Illustrations are used as an example and might show other productsthan the one the manual describes. The example that is illustrated isstill valid.1.5 IEC 61850 edition 1 / edition 2 mappingGUID-C5133366-7260-4C47-A975-7DBAB3A33A96 v4Function block names are used in ACT and PST to identify functions. Respectivefunction block names of Edition 1 logical nodes and Edition 2 logical nodes areshown in the table below.Table 1:IEC 61850 edition 1 / edition 2 mappingFunction block name Edition 1 logical nodes Edition 2 logical nodesAEGPVOC AEGGAPC AEGPVOCAGSAL AGSALSECLLN0AGSALALMCALH ALMCALH ALMCALHALTIM - ALTIMALTMS - ALTMSALTRK - ALTRKBCZPDIF BCZPDIF BCZPDIFBCZSPDIF BCZSPDIF BCZSPDIFBCZTPDIF BCZTPDIF BCZTPDIFBDCGAPC SWSGGIO BBCSWIBDCGAPCBDZSGAPC BBS6LLN0BDZSGAPCLLN0BDZSGAPCTable continues on next pageSection 1 1MRK 502 073-UEN AIntroduction16 Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062Commissioning manual
