10Remote user (via X100 extender)Up to four users can be placed amaximum of 300 metres (980 feet)from the AdderView CATx unit.Remote users are connected via anAdder X100 extender module andsuitable category 5, 5e or 6 cabling(with no crossover). The AdderViewCATx IP models provide two remoteuser ports.Cable lengths for remote user locationsThe maximum length of cable between a remote user and the AdderView CATxunit can be up to 300 metres (980 feet). However, bear in mind that the overalldistance between any remote user and any computer system must not exceed300 metres (980 feet).In situations where any computer system will be placed a significant distancefrom the AdderView CATx unit, ensure that the distance to any remote user issimilary less than 300 metres (980 feet).To connect a remote user1 Place an Adder X100 extender unit adjacent to the remote user location.2 Attach the video monitor,keyboard, mouse, poweradapter (and speaker)connectors to the socketsof the Adder X100module.3 Lay a suitable length of category 5, 5e or 6 cabling between the Adder X100module and the AdderView CATx unit. Please refer to the section Cablelengths for remote user locations opposite.4 Attach the connector of the cable run to the socket of the Adder X100.5 At the other end of the cable run, attach the cable connector to one of thesockets labelled CATx USER PORTS on the rear panel of the AdderView CATxunit.From mouseFrom keyboardFrom video monitorFrom power adapterCategory 5, 5e or6 cable leading toAdderView CATx unitCategory 5, 5e or 6 cablefrom Adder X100 module6 Where necessary, use the in-built video compensation feature of the AdderX100 module to eliminate any effects caused by the cable run. However,ensure that the links between the computers and the AdderView CATx havebeen compensated first. See remote user video compensation for details.Adder X100moduleAdder X100moduleAdderView CATxrear panelNote: The AdderViewCATx model shown hereis a non-IP version. TheIP-version provides onlyremote user ports 3and 4.
