34What to do if the ADMIN password has been forgottenIf the ADMIN password becomes mislaid or forgotten, you will not be ableto access the AdderView CATx to add or edit users and computer names.This situation may be resolved by performing a complete reset to return theAdderView CATx or CATx IP to its factory default state.IMPORTANT: A complete reset erases all the user names and computernames that you have setup.Slightly different procedures are used to reset the AdderView CATx and theAdderView CATx IP, as detailed here.To reset AdderView CATx models1 Remove all power inputs from the AdderView CATx unit.2 Move switch 3 on the rear panel down to the ON position.3 Press and hold the front panel USER and COMPUTER buttons while you re-apply power. On the local user port, a screen menu will indicate that the unithas been reset and will prompt you to power down and return the switch toits normal position.4 As directed, remove power and move switch 3 up to its OFF position.5 Power up and configure the unit in the normal manner.To reset the AdderView CATx IP models1 Remove all power inputs from the AdderView CATx IP unit.2 Move switch 2 on the rear panel down to the ON position.3 Re-apply power to the unit. On the local user port, a screen menu willprovide two options.4 Using the local keyboard or mouse, select the ‘Reset Configuration’ option.A warning screen will be displayed, select the RESET option and press .The unit will reset and then prompt you to work through the initial IPconfiguration screens.5 After you have completed the initial IP configuration, remove power andmove switch 2 up to its OFF position.
