ADJ VIZI BEAM RXONE User Manual

Also see for VIZI BEAM RXONE: User instructions

Vizi Beam RXONE System MenuSystem Menu: When making adjustments press ENTER to confirm your setup then press andhold the MENU button for at least 3 seconds. To exit without making any adjust-ments pressthe MENU button. The display will lock after 30 seconds, press the MENU button for 3 sec-onds to unlock.DMX Address - Set the DMX Address.1. Press the MENU button until “DMX Addresss” is displayed, and press ENTER.2. “X” will now be displayed, where “X” represents the displayed address. Press the UP or DOWNbuttons to find your desired address.3. Press ENTER to confirm, and then press and hold the MENU button for at least three seconds toassign.Channel Mode - This will let you select your desired DMX Channel mode.1. Press the MENU button until “Channel Mode” is displayed, and press ENTER.2. “X Chan” will now be displayed, where “X” represents the displayed DMX channel mode. Pressthe UP or DOWN buttons to find your desired Channel mode.3. Press ENTER to confirm.Show Mode - Show modes 1 - 4 (Factory Shows).1. Press the MENU button until “Show Mode” is displayed, and press ENTER.2. “Show X” will now be displayed, “X” representing a number between 1-4. Press the UP or DOWNbuttons to find your desired show and press ENTER to confirm. After pressing ENTER, press andhold the MENU button for at least 3 seconds to activate.Pri/Sec Mode - This will let you set unit as a primary or secondary in primary/secondary mode.1. Press the MENU button until “Pri/Sec Mode” is displayed, and press ENTER. Either “Pri”, “Sec 1”or “Sec 2” will be displayed.2. Press the UP or DOWN buttons until your desired setting is displayed, then press ENTER to con-fim.NOTE: In a Primary/Secondary configuration you can make one fixture the Primary and then set thenext fixture to “Sec 2”, the fixtures will now have contrast movement to each other.DMX Last State - This mode defines how the fixture will behave in the event that the DMX sig-nal is lost or interrupted.1. Press the MENU button until “DMX Last State” is displayed, and press ENTER.2. Either “Pri Sec”, “Blackout”, or “Last State” will be displayed. Choose an operating mode youwould like the unit to start up in when power is applied or the DMX signal is lost.• Primary/Secondary - If the DMX signal is lost or power is applied, the unit will automaticallygo into Primary/Secondary mode.• Blackout - If the DMX signal is lost or power is applied, the unit will automatically go intostand by mode.• Last State - If the DMX signal is lost the fixture will stay in the last DMX set up. If power isapplied and this mode is set, the unit will automatically go into the last DMX set up.3. Press ENTER to confirm your desired set up.ADJ Products, LLC - www.adj.com - Vizi Beam RXONE User Manual Page 28