ADJ VIZI BEAM RXONE User Manual

Also see for VIZI BEAM RXONE: User instructions

Vizi Beam RXONE System MenuSound State - In this mode the unit will run in sound active mode.1. Press the MENU button until “Sound State” is displayed, and press ENTER.2. Either “On” or “Off” will now be displayed. Use the UP or DOWN buttons to toggle between “On”and “Off”.3. Press ENTER to confirm your selection, then press and hold the MENU button to activate.Sound Sense - In this mode you can adjust the sound sensitivity of the sound active mode.1. Press the MENU button until “Sound Sense” is displayed, and press ENTER.2. Press the UP or DOWN buttons to adjust the sensitivity level. The sensitivity level can be adjust-ed between 0 (the lowest) and 100 (most sensitive).3. Press ENTER to set you desired level.Pan Invert - Pan Inversion1. Press the MENU button until “Pan Invert” is displayed, and press ENTER. Either “Invert” or “Nor-mal” will be displayed.2. To activate the Pan inversion press the UP or DOWN buttons until “Invert” is displayed, and pressENTER to confim. To deactivate Pan inversion, select “Normal” and press Enter.Tilt Invert - Tilt Inversion1. Press the MENU button until “Tilt Invert” is displayed, and press ENTER. Either “Invert” or “Nor-mal” will be displayed.2. To activate the Tilt inversion press the UP or DOWN buttons until “Invert” is displayed, and pressENTER to confim. To deactivate Tilt inversion, select “Normal” and press Enter.Back Light - With this function you can make the backlight automatically turn off after oneminute.1. Press the MENU button until “Back Light” is displayed, and press ENTER.2. Either “On” or “Off” will now be displayed. Press the UP or DOWN buttons to select “On” to keepthe backlight on at all times, or “Off” to allow the backlight to turn off after 1 minute. Press anybutton to turn the backlight on again.Auto Test - This function will run a self test program.1. Press the MENU button until “Auto Test” is displayed, and press ENTER.2. The fixture will now run a self test. Press the MENU button to exit.Fixture Time - With this function you can display the running time of the unit.1. Press the MENU button until “Fixture Time” is displayed, and press ENTER.2. The running time of the fixture will now be displayed. Press MENU to exit.Lamp Time - This function will allow you to view the running lifetime of the installed lamp. Thefunction also lets you reset the lamp running time when a new lamp as been installed.1. Press the MENU button until “Lamp Time” is displayed, and press ENTER. The current lamp timewill be displayed.2. Press ENTER again, and “Reset” will be displayed. Press ENTER to reset the lamp time to 0. Onlyreset the lamp time when installing a new lamp. If you don’t wish to reset the lamp time press theMENU button.ADJ Products, LLC - www.adj.com - Vizi Beam RXONE User Manual Page 29