Menu Descriptions61179641L4-5B 5-57Dynamic IP Settings - for IP over ATM MenuDynamic IP Settings - for IP over ATMMain Menu\System Management\Mode Selection and Current IP Settings\Dynamic IP Settings - for IP over ATM\The Dynamic IP Settings - for IP over ATM menu (see Figure 5-34) is used to provision some ofthe IP settings. When the Mode option is set to Dynamic, the Total Access 1248 systemautomatically retrieves the IP address, Subnet mask, and Default Gateway from the remoteDHCP server. The remaining menu items can be provisioned manually.Figure 5-34. Dynamic IP Settings - for IP over ATM MenuThe Dynamic IP Settings - for IP over ATM menu items are shown in Table 5-34.Table 5-34. Dynamic IP Settings - for IP over ATM Menu ItemsOption Description FunctionN/A IP address This option cannot be changed. The IP address isautomatically retrieved from the DHCP server.N/A Subnet mask This option cannot be changed. The Subnet mask isautomatically retrieved from the DHCP server.3 VPI/VCI This option is used to configure the VPI/VCI setting. TheVPI and VCI are used to identify the next destination of acell as it passes through a series of ATM switches.The VPI/VCI must also be provisioned at the upstreamATM device.4 PCR This option is used to configure the Peak Cell Rate(PCR). The PCR is the maximum number of cells persecond that the ATM can transmit. The PCR default is3000. Valid values range from 0 to 14488.TID: TA1248 Total Access 1248Unacknowledged Alarms: NoneDynamic IP Settings - for IP over ATMIP address 0.0.0.0Subnet mask 0.0.0.03. VPI/VCI 0/324. PCR 3000Default Gateway Not Configured6. TFTP IP address Not Configured7. TL1 Port Number(set >1023) 130018. TL1 IP Transport type TCP9. Reset IP Factory DefaultsMAC Address 00-a0-c8-12-6d-f9Encapsulation is via rfc1483 SNAPSelection :'?' - System Help Screen
