Altos R5250 Installation Configuration Guide 92ATI FireGL V5200 8.35.5 \Disk\R5250\graphic\V5200\rhel5Software RequiredThe management utility for LSI MegaRAID SAS 8204ELP can be found in theEasyBUILD 8.0 build 100 (or later).Software Version Directory on EasyBUILDMegaRAID StorageManager2.30 \app\R5250\sas\8204ELP\Linux\Configuring LSI MegaRAID SAS 8204ELPPlease refer to the Appendix D. for the LSI MegaRAID SAS 8204ELPconfiguration.Installation Tips1. Since Red Hat Enterprise Linux 5 cannot recognize the MegaRAID SAS8204ELP, you need to make a driver diskette from the EasyBUILD 8.0 build100 (or later) first before the installation.2. Type linux dd when the prompt boot: appears at the start.3. Please select the sda as the Driver Disk Source.4. Follow the instruction to load the driver for MegaRAID SAS 8204ELP fromthe driver diskette.5. When installing MSM (MegaRAID Storage Manager) for MegaRAID SAS8204ELP after installation complted OR if you have installed the ATIFireGL V5200 in the system, you are required to manually to select/installadditional package at the Package Installation Defaults.6. At the Package Installation Defaults, select Customize software packagesto be installed and click Next.7. At the Package Group Selection step, hold the shift key to select all thelisted packages in the right pane under Development, and right click onall the items you just selected and then click “Select all optionalpackages”.8. After selecting the entire package under Development, click Next tofollow the normal procedure to finish the installation.Gigabit Ethernet Driver InstallationThe Gigabit Ethernet driver installation is the same as SAS daughter boardinstalled. Please refer to the Red Hat Enterprise Linux 5.0 Installation (SASDaughter Board) Gigabit Ethernet Driver Installation section.VGA Driver Installation (onboard XGI Z9s)The XGI Z9s driver installation is the same as SAS daughter board installed.Please refer to the Red Hat Enterprise Linux 5.0 Installation (SAS Daughter
