4-8RAIDUTIL Command Line UtilityController-Specific-a Action (task) controlThis switch has the following options which allow you to controltasks on the controller:Specify drives by the device address.-F Update controller firmware, BIOS, or NVRAMThis option updates the controller flash memory (EEPROM). Specifyan image file name on the command line.Note: The -F switch does not work on Novell NetWaresystems. Use SMOR to update the controller flash memory.For additional information, see Chapter 2, Storage Manageron ROM.-X Reset NVRAM configurationThis option resets the controller NVRAM to the factory defaultsettings.-Z Reset/clear embedded RAID informationThis option destroys all RAID information pertaining to disk arraysand logical drives for the specified device. Specify logical drives byusing the device address.List Shows tasks for the controllerBuild Starts build of logical driveRebuild Starts rebuild on logical driveVerify Starts a verify operationStop Terminates active task on drive
