5-78Adaptec SCSI RAID Software Reference GuideParameters{container}Specifies the ID number (0 to 63) of the array you want toreconfigure.{scsi_device}...Specifies one or more SCSI devices. Typically, you specify oneor more SCSI devices when adding more drives to an array ormoving an array’s partitions. A SCSI ID consists of a SCSIchannel number (for example, 0, 1, 2, 3, etc.), a SCSI device ID(0 through 15 inclusive), and a SCSI device logical unit number(0 through 7 inclusive). See the scsi_device section onpage 3-7 for more information on how to specify the SCSIdevice. The command uses the freespace(s) from the SCSIdevice(s) you specify to reconfigure the array.Switches/stripe_size{=integer}Specifies the changed stripe size for the array. You can specifystripe sizes for the following types of arrays:■ RAID-5 set■ Multilevel stripe set:– Stripe set of mirror sets– Stripe set of volume sets– Stripe set of stripe sets/extend_fs{=boolean}Specifies whether to extend the file system so that it occupiesthe entire reconfigured array. If you specify TRUE, thecommand adds no new freespace and extends the file systemso that it occupies the entire reconfigured array. (Thecommand extends the file system after completing thereconfigure operation.) If you specify FALSE, the commandadds freespace to the reconfigured array and does not extendthe file system to occupy the entire reconfigured array.This switch defaults to FALSE.
