5-5container Commandscontainer create mirrorTo create a mirror set from a single-partition volume set andfreespace, use the container create mirror command. Anydata on the original volume set remains intact during mirrorcreation and the user sees no interruption in service.If you created a mirror set on a NetWare server, you can run thelist devices command on the NetWare console to verify itscreation and then create the necessary NetWare disk partitions andvolumes.For information on how to create partitions and volumes, see theappropriate NetWare documentation.Syntaxcontainer create mirror [/wait{=boolean}][/io_delay{=integer}] {container} {scsi_device}Parameters{container}Specifies the ID number (0 to 63) of the array on which tocreate a mirror set. You create a mirror set from a single-partition volume set.{scsi_device}Specifies the ID for the SCSI device whose freespace you wantto use for mirroring the volume set specified in the containerparameter. A SCSI ID consists of a SCSI bus number (e.g., 0, 1,2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSIdevice logical unit number (0 through 7 inclusive). See theinstallation guide for your controller to determine the numberof buses it actually supports.See the scsi_device section on page 3-7 for moreinformation on how to specify the SCSI device.
