5-104Adaptec SCSI RAID Software Reference GuideThe following example assigns two SCSI failover disks to all arrays.If you assign only one SCSI disk as a failover device, ensure thatthere is sufficient freespace. If you assign more than one SCSI disk asfailover devices, you need ensure that only one of these disks hassufficient space. The reason for this is that the failover operation willlook for the disk that has enough space.AAC0>container set global_failover (1,2,0) (1,3,0)Executing: container set global_failover (CHANNEL=1,ID=2,LUN=0)(CHANNEL=1,ID=3,LUN=0)Use the container show failover command (with or without the/global switch) after using the container set failovercommand to display information about the array(s) just assignedfailover disk(s), as in the following example:AAC0>container show failover /globalExecuting: container show failover /global=TRUEcontainer Scsi C:ID:L--------- ----------------------------------GLOBAL 1:02:0 1:03:0As the example shows, the display indicates that SCSI devices (1,2,0)and (1,3,0) are assigned as failover devices for all arrays (the wordGLOBAL appears in the array column).Related Informationcontainer commands:■ container list (page 5-54)■ container remove failover (page 5-86)■ container remove global_failover (page 5-90)■ container set failover (page 5-101)■ container show failover (page 5-116)
