11-5enclosure Commandsenclosure identify slotTo identify a slot on a specified SAF-TE enclosure managementdevice, use the enclosure identify slot command. Typically,an enclosure management device indicates to the operator whichslot is currently being identified by flashing an adjacent light.Syntaxenclosure identify slot {enclosure} {slot}Parameters{enclosure}Specifies the ID associated with the enclosure managementdevice on which you want to identify a slot. For this version,the controller supports a maximum of eight enclosuremanagement devices on each bus.{slot}Specifies the unit number associated with the slot. This is theslot that you want the enclosure management device toidentify. This unit number can range from 0 to 15 inclusive.Typically, the slot unit number is limited by the physicalnumber of device slots in the enclosure management device.Switches/stop{=boolean}Specifies whether to stop the identification of the specified slot.If you set this switch to TRUE, the command stopsidentification of the specified slot. Typically, you use thisswitch to stop the identification of a slot that you previouslyidentified with the enclosure identify slot command.This switch defaults to FALSE.ExamplesThe following example shows how to identify slot 1 in enclosuremanagement device 0 using the enclosure identify slot command:AAC0>enclosure identify slot 0 1Executing: enclosure identify slot 0 1
