VoiceFinder AP1100 VoIP Gateway User’s Guide Version 1.1AddPac Technology Co., Ltd. - 202 -5.7.3.8.2. Default ValueOne Ring5.7.3.8.3. Command ModeVoice-port configuration Mode5.7.3.8.4. Usage GuidelineUse the ring number command to set the maximum number of rings to bedetected before answering a call over an FXO voice port. Use the no form ofthis command to reset the default value, which is one ring.Normally, thiscommand should be set to the default so that incoming calls are answeredquickly. If you have other equipment available on the line to answer incomingcalls, you might want to set the value higher to give the equipment sufficienttime to respond. In that case, the FXO interface would answer if the equipmenton line did not answer the incoming call in the configured number of rings.Thiscommand is not applicable to FXS or E&M interfaces because they do notreceive ringing to receive a call.5.7.3.8.5. ExamplesThe following example on the router sets five rings as the maximum number ofrings to be detected before closing a connection over this voice port:voice-port 1/1ring number 55.7.3.9. shutdown (voice-port)To take the voice ports for a specific voice interface card offline, use theshutdown voice-port configuration command. Use the no form of thiscommand to put the ports back in service.shutdown
