VoiceFinder AP1100 VoIP Gateway User’s Guide Version 1.1AddPac Technology Co., Ltd. - 207 -The “answer-address” command is used to find the VoIP dial peer for the VoIPinbound call incoming to the network.The VoIP dial peer for the VoIP inbound call from the network is selected asfollows:Firstly, the VoIP dial peer that has the session target matching with the IPaddress of the inbound call is searched.Secondly, if the corresponding peer is not found, the VoIP dial peer that hasanswer-address matching with the calling party number of the inbound call willbe searched.Lastly, if no peer is found, the VoIP dial peer matching with thedestination-pattern of the inbound call will be searched.5.7.4.1.5. ExamplesIn the following example, if the calling party number of the inbound VoIP call is“5263848” VoIP peer 10 will be selected.dial-peer voice 10 VoIPanswer-address 526....5.7.4.2. codecTo specify the voice coder rate of speech for a dial peer, use the codecdial-peer configuration command. Use the no form of this command to resetthe default value.codec {g711alaw / g711ulaw / g729r8 / g7231r63 / g7231r53 }no codec5.7.4.2.1. SyntaxKeyword / Argument DescriptionG711alaw G.711 A-Law 64Kbps CodecG711ulaw G.711 u-Law 64Kbps CodecG729 G.729 8Kbps CodecG7231r63 G.723.1 6300 bps. This is the default CODEC forAP1100 Gateway.
