VoiceFinder AP1100 VoIP Gateway User’s Guide Version 1.1AddPac Technology Co., Ltd. - 28 -3.2. Environment ConfigurationThe Gateway requires various configurations of parameters according to theapplication. This section provides important information for using the Gatewayand the user is highly advised to follow the following procedures beforeconfiguring the Gateway.z Clarify the network address according to the IP with the network diagram..z Determine which routing protocol to use. (e.g. Static, Default etc.) In doingso, discussion with the administrator of the connecting network is required.z Determine the protocol to use with each LAN 1(WAN) port. (e.g. PPPoE,Ethernet etc.)z When the conditions above are determined, thoroughly understand therelated commands.Environment configuration is required only once at initial installation. But whenthe network components have changed, settings must be reconfigured. Atcompletion of configuration, always save the settings to prevent loss of datawhen switching the power on/off.In order to log in at an unconfigured Gateway, the user must use a setusername and password. The user access authority for VoiceFinder 1100 isdivided into 4 levels : admin, high, normal, low. All users, other then Admin isprompted “1router>” at log-in.The user must log-in at admin level for Gateway configuration. Factory settingsfor admin level log-in uses “root” for username and “router” for password. Theuser is prompted with “1Gateway#” for Admin level log-in and is allowed toconfigure the equipment.VoiceFinder 1100 configuration is divided into two parts : Global Configuration,Information
