14 V6.70 20131017To install the probe into the thermo well:1. Select the appropriate thermo well adapter fitting and either wrap the malethreads with Teflon tape or coat with suitable pipe dope compound. Oncethe male threads are prepared, thread the adapter fittings into the thermowell.2. If the probe well’s ID is greater than 0.390 select the appropriate probesleeve and slide over the probe. Tighten the set screw with theaccompanying Allen Key.3. Slide the probe into the thermo well.4. Ensure that the snap elbow fitting is fully open. Apply Teflon tape to themale threads of the snap elbow fitting. Thread the snap elbow into thefemale threads of the thermo well adapter fitting. The spring holds theprobe at the end of the well.5. Close the elbow, forming a 90 degree right angle. Tighten the domedstrain relief until the insert is tight against the probe cable.3.3.2 TTC-PROBE-11 InstallationProbe type TTC-PROBE-11 allows coupling of flexible conduit directly to thethermometer well adapter fittings provided. Its unique design allows the probe tobe held in the well. Figure 3.5 illustrates this assembly.Figure 3.5: PROBE-11 InstallationTo install the probe into the thermo well:1. Select the appropriate thermo well adapter fitting and either wrap the malethreads with Teflon tape or coat with suitable pipe dope compound. Oncethe male threads are prepared, thread the adapter fittings into the thermowell.1/2 NPTLiquid TightFittingNot IncludedFlexible ConduitNot IncludedBrass Fittings(Included)Washer(Included) Spring(Included)Washer(Included)ProbeThermometer WellProbeSleeve(Included)
