AXIS 5800+ Mobile User’s Manual Section 5 Setting Up - Windows 55Note: • Even if the desired printer is available in the Manufacturer andPrinter Models list, you are advised to use the printer driverprovided with your printer. This assures you of the latest driversoftware.4. Select Other... in the driver list. Insert the printer driverdiskette/CD that was provided with your printer, select theappropriate diskette/CD drive and click OK.5. Select the printer driver you want to install.6. Select Other... in the “Print to” list box.7. Select Axis Port from the list of available Print Monitors andclick OK.8. Select the AXIS Port you wish to add and then click OK. The portsappear as .LP1 and .LP2, where is AXfollowed by the last six digits of the AXIS 5800+ Mobile serialnumber, e.g. AX100086 (default serial no.).9. Click on Settings. Choose whether error condition pop-upmessages are to be displayed by checking the box in theConfigure Axis Ports dialog. Click OK.Using the Microsoft LPD monitor with WindowsUsing the MicrosoftLPD monitor withWindows 2000/XPThis section describes how to set up a Windows 2000/XP serverfor LPR printing over the TCP/IP protocol, using the built-inMicrosoft LPD monitor i.e. Print Services for Unix.Note: • See Alternative Method for LPR Printing, on page 57 forinstructions on how to set up printing over LPR without installingPrint Services for Unix.Basic Setup If you have not already done so, you should perform the TCP/IPbasic setup procedures prior to installing a printer for LPDprinting.
