Section 6 Setting Up - NetWare AXIS 5800+ Mobile User’s Manual62Setup using NDPSThe AXIS 5800+ Mobile supports Novell Distributed PrintServices (NDPS), which is Novell’s new generation architecturefor printing and printer administration. You can run NDPS overPure IP (TCP/IP) or IPX/SPX.Before the AXIS 5800+ Mobile can be installed, make sure thatNDPS is installed and a Broker is loaded on your NetWare fileserver.AXIS 5800+ Mobile uses the AXIS NDPS Gateway for printingin networks using either IP or IPX as transport protocols. Theprinter gateways are included with the NDPS software (fromversion 5.1 and up) and are automatically installed together withNDPS.Notes: • NDPS requires that you run NetWare 4.11 or higher.• Pure IP is only supported by NetWare 5 or higher.Installing the AXIS 5800+ Mobile in an NDPS environmentsHaving assigned an IP address to the AXIS 5800+ Mobile asdescribed in Assign an IP address to the print server, on page 23,you are now ready to install the AXIS 5800+ Mobile for NDPSprinting. You can select to install the connected printers aspublic or controlled access printers. Follow the instructionsbelow to install the AXIS 5800+ Mobile using NDPS:Notes: • The HP-JETADMIN parameter of the AXIS 5800+ Mobile must beset to YES in order for the communication between the AXIS5800+ Mobile and the NDPS gateway to be enabled. Set thisparameter in the print server’s internal web pages: admin |General Settings | HP JetAdmin Support (default value=NO)• If you do not have an NDPS Manager object available, start outwith creating one in the NetWare Administrator.
