Axis M1137 User Manual

Also see for M11 Network Camera Series: User manual User manual User manual User manual Installation guide

AXIS M11 SeriesThe device interfacePassword: Enter a password for the username.Client ID: Enter a client ID. The client identifier is sent to the server when the client connects to it.Clean session: Controls the behavior at connection and disconnection time. When selected, the state information is discardedat connect and disconnect.Keep alive interval: The keep alive interval enables the client to detect when the server is no longer available without havingto wait for the long TCP/IP timeout.Timeout: The time interval in seconds to allow a connect to complete. Default value: 60Reconnect automatically: Specifies whether the client should reconnect automatically after a disconnect.Connect messageSpecifies if a message should be sent out when a connection is established.Send message: Turn on to send messages.Use default: Turn off to enter your own default message.Topic: Enter the topic for the default message.Payload: Enter the content for the default message.Retain: Select to keep the state of client on this TopicQoS: Change the QoS layer for the packet flow.Last Will and Testament messageThe Last Will Testament (LWT) lets a client provide a testament along with its credentials when connecting to the broker. If theclient disconnects ungracefully at some point later (maybe because his power source died), it can let the broker deliver a messageto other clients. This LWT message has the same form as an ordinary message and gets routed via the same mechanics.Send message: Turn on to send messages.Use default: Turn off to enter your own default message.Topic: Enter the topic for the default message.Payload: Enter the content for the default message.Retain: Select to keep the state of client on this TopicQoS: Change the QoS layer for the packet flow.MQTT publicationUse default condition prefix: Select to use the default condition prefix, that is defined in the MQTT client tab.Include condition name: Select to include the topics that describe the condition in the MQTT topic.Include condition namespaces: Select to include ONVIF topic namespaces in the MQTT topic.Include serial number in payload: Select to include the device’s serial number in the MQTT payload.Add condition: Click to add a condition.Retain: Defines which MQTT messages are sent as retained..• None: Send all messages as non-retained.33