Banner Q4X Instruction Manual

Also see for Q4X Series: Quick start guide Instruction manual Quick start guide Quick start guide Quick start guide

Banner Q4X Instruction Manual Manual pdf 10 page image

Two-Point Static TeachDynamic TeachBackground SuppressionForeground SuppressionTop Menu Sub Menuoff: no delays enabledon: enable on and/or off delay (set value in Delay Timer menu)1 Shot, fixed output pulse durationTotalend: exit setupTeach Selection CH2Output CH2Window Size CH2 **Output Timing Delays CH2Offset CH2 ****Exit Setup( default setting)Light OperateDark OperateComplimentary to Output 2Dual ModeAdaptive Tracking CH2 *off: Adaptive Tracking offHigh-Speed Adaptive Tracking onon: Adaptive Tracking onChannel 2Adaptive Tracking menu is available when Teach CH2 is set to Dual Modelaser off when pulled highlaser on when pulled highset: Remote Teach inputmasterslavepulsesec range, set Delay Timer value (seconds have decimal)tomsMenu not present when is set to( and default to 0, defaults to 1 or 10 depending on response speed setting)Delay Timer CH2 ***Available whenset toAvailable whenset toavailable whenset toorMenu items only available whenout2 is set to LO or DO=AutoSet Value:Offset menu is available when Teach CH2 is set to FGS or BGS-75 to 75 for 100/110 mm models-275 to 275 for 300/310 mm models-575 to 575 for 600/610 mm models0.2 to x, where x depends on measuring span:Window Size menu is available when Teach CH2 is set to FGS75 for 100/110 mm models275 for 300/310 mm models575 for 600/610 mm modelsFigure 13. Sensor Menu Map—Channel 23.2.1 OutputNote: The number that follows out on the display indicates which channel is selected.The Output 1 menu is available in Channel 1. Use this menu to select light operate (LO) or dark operate (DO). The default outputconfiguration is light operate. To switch between light operate and dark operate, select the desired menu option.• —Light operate• —Dark operateThe Output 2 menu is available in Channel 2. Use this menu to set the output configuration for Channel 2. The default is lightoperate.• —Light operate• —Dark operateQ4X Stainless Steel Laser Sensor with Dual Discrete Outputs and IO-Link10 www.bannerengineering.com - Tel: 763.544.3164