Banner Q4X Instruction Manual

Also see for Q4X Series: Quick start guide Instruction manual Quick start guide Quick start guide Quick start guide

Banner Q4X Instruction Manual Manual pdf 14 page image

• 10 milliseconds for 10, 15, 25, and 50 millisecond response speeds• 1 millisecond for 1.5, 2, 3, and 5 milliseconds response speedsUse and to scroll through the values. Millisecond values do not include the decimal point; seconds values include thedecimal point.• 1 to 999 ms (when is selected, the 1 to 9 ms range is available for 1.5, 2, 3, and 5 ms response times)• 1.0 to 90.0 sTotalizerThe totalizer function changes the output only after counting a designated number of targets. After selecting this function,or become available to define the output duration and or to define required number of counts before theoutput changes.For and , the default is 1 count.For and , the default is 10 milliseconds. Use and to scroll through the values. Millisecond values do notinclude the decimal point; seconds values include the decimal point.• 1 to 999 ms (when or is selected, the 1 to 9 ms range is available for 1.5, 2, 3, and 5 ms response times)• 1.0 to 90.0 sFrom Run mode, press SELECT to change the display to show the current totalizer count. Pressing SELECT again changes thedisplay back to the measured distance.The totalizer count automatically resets after re-teaching the switch point distance or turning the sensor off.3.2.9 Zero Reference LocationUse this menu to select the zero reference location. The default is , 0 = the front of the sensor. This menu is not available indual (intensity + distance) mode.• —0 = the front of the sensor; the measurement increases further from the sensor• —0 = maximum range; the measurement increases closer to the sensor3.2.10 Shift the Zero Reference Location after a TEACHUse this menu to select whether the sensor shifts the zero reference location based on the last TEACH process. The default is, 0 = the front of the sensor or the maximum range. This menu is not available in dual (intensity + distance) mode.• —Shift the zero reference location to one of the taught positions with each TEACH• —0 = the front of the sensor or the maximum range, depending on the settingThis figure illustrates three examples of how changes to the zero and shift settings affect what distance readout is shown on thedisplay when in 2-pt TEACH mode. Changes to the zero setting affect the direction in which the distance increases.Q4X Stainless Steel Laser Sensor with Dual Discrete Outputs and IO-Link14 www.bannerengineering.com - Tel: 763.544.3164