9.8.1 Network SettingsNetwork Settings: Modbus/TCP, Ethernet/IP, PCCCFigure 88. Network SettingsClick Network Settings on the Software to open the Network Settings window. In the case of a Modbus/TCP connection,the default TCP port used is 502, by specification. This value is not shown in the Network Settings window.Table 5: Default Network SettingsSetting Name Factory Default ValueIP Address 192.168.0.128Subnet Mask 255.255.255.0Gateway Address 0.0.0.0Link Speed and Duplex Mode Auto NegotiateThe Advanced option allows further configuration of Modbus/TCP and EtherNet/IP settings, such as Swap character bytes,MSW and LSW sending precedence, and String Length Type (EtherNet/IP and PCCC).Click Send to write the network settings to the Safety Controller. Network settings are sent separately from theconfiguration settings.Click Network Timeout Enabled to have any configured Virtual On/Off or Virtual Mute Enable become inactive in the event ofa network timeout condition. The network timeout time is fixed at 5 seconds.Note: Use Password Manager to enable or disable the ability for User2 and User3 to change the networksettings.XS/SC26-2 and SC10-2 Safety Controllerswww.bannerengineering.com - Tel: + 1 888 373 6767 103
