Banner XS26-2 Series Instruction Manual

Contents

Banner XS26-2 Series Instruction Manual Manual pdf 23 page image

6 System Installation6.1 Installing the SoftwareImportant: Administrative rights are required to install the Safety Controller drivers (needed forcommunication with the controller).1. Download the latest version of the software fromwww.bannerengineering.com/safetycontroller.2. Navigate to and open the downloaded file.3. Click Next to begin the installation process.4. Confirm the software destination and availability for users and click Next.5. Click Next to install the software.6. Depending on your system settings, a popup window may appear prompting to allow Banner Safety Controller tomake changes to your computer. Click Yes.7. Click Close to exit the installer.Open Banner Safety Controller from the Desktop or the Start Menu.6.2 Installing the Safety ControllerDo not exceed the operating specifications for reliable operation. The enclosure must provide adequate heat dissipation sothat the air closely surrounding the Safety Controller does not exceed its maximum operating temperature (seeSpecifications and Requirements on page 16).Important: Mount the Safety Controller in a location that is free from large shocks and high-amplitudevibration.CAUTION: Electrostatic Discharge (ESD) can cause damage to electronic equipment. To prevent this,follow the proper ESD handling practices such as wearing an approved wrist strap or other groundingproducts, or touching a grounded object before handling the modules. See ANSI/ESD S20.20 for furtherinformation about managing ESD.6.2.1 Mounting InstructionsThe Safety Controller mounts to a standard 35 mm DIN-rail track. It must be installed inside an enclosure rated NEMA 3(IEC IP54) or better. It should be mounted to a vertical surface with the vent openings at the bottom and the top to allow fornatural convection cooling.Follow the mounting instructions to avoid damage to the Safety Controller.To mount the SC26-2 Programmable Safety Controller, XS26-2 Programmable Safety Controller, XS2so and XS4so Solid-State Safety Output Modules, XS8si and XS16si Safety Input Modules, XS1ro and XS2ro Safety Relay Modules, and SC10-2Safety Controller:1. Tilt the top of the module slightly backward and place it on the DIN rail.2. Straighten the module against the rail.3. Lower the module onto the rail.To remove the SC26-2 Programmable Safety Controller, XS26-2 Programmable Safety Controller, XS2so and XS4so Solid-State Safety Output Modules, XS8si and XS16si Safety Input Modules, XS1ro and XS2ro Safety Relay Modules, and SC10-2Safety Controller:1. Push up on the bottom of the module.2. Tilt the top of the module slightly forward.3. Lower the module after the top rigid clip is clear of the DIN rail.Note: To remove an expansion module, pull apart other modules on each side of the desired module tofree bus connectors.XS/SC26-2 and SC10-2 Safety Controllerswww.bannerengineering.com - Tel: + 1 888 373 6767 23