Generic SC10-2 Hookup: Safety Output with EDM243414+24Vdc+24Vdc0Vdc0VdcL2/-VL1/+V EDMSC10233313Safety Relay Outputs 43/44,53/54 and 63/64 can bewired similarly, but require aseparate EDM or AVM inputfor monitoring.MPCE1MPCE2Arc SuppressorsMachineControlCircuitFeedback Loop (optional)Figure 42. Generic SC10-2 Hookup: Safety Relay Output (Dual-Channel) with EDM7.9 Status Outputs7.9.1 Status Output Signal ConventionsNote: You cannot use the safety outputs as status outputs in the SC10-2.There are two signal conventions selectable for each status output: "PNP On" (sourcing 24 V dc), or "PNP Off" (non-conducting). The default convention is Active = PNP On.Table 4: Status Output Signal ConventionsFunctionSignal ConventionsActive = PNP On Active = PNP OffStatus Output State Status Output State+24 V dc Off Off 24 V dcBypass Bypassed Not Bypassed Bypassed Not BypassedMute Muted Not Muted Muted Not MutedOutput Delay In Progress Delay No Delay Delay No DelayTrack Input Run Stop Run StopTrack Input Fault Fault Ok Fault OkTrack Any Input Fault Fault Ok Fault OkTrack Input Group Initiated Stop Other Input Caused Stop Initiated Stop Other Input Caused StopTrack Output SO On SO Off SO On SO OffTrack Output Fault Fault Ok Fault OkTrack Output Fault All Fault Ok Fault OkXS/SC26-2 and SC10-2 Safety Controllerswww.bannerengineering.com - Tel: + 1 888 373 6767 59
