• If the Link Status indicates that there is no link, please inspect the wiring, and verify that your Ethernet switch is powered up.• If the link parameters are not as expected (wrong baud rate or duplex) try the following:• Log into your managed switch and verify that the port to which iVu camera is connected is correctly configured. Alternatively,consult with your IT person to perform this verification.• Verify that your cable is of the right type, and is properly connected to the switch and to the camera.9.8.2 Networking and TCP/IP DiagnosticsTo verify networking and TCP/IP connectivity, follow these steps:• Verify that the Ethernet link has been established.• Visit the System > Communications > Ethernet I/O page, and examine the sensor IP address, subnet mask, and the Gatewayaddress:• Verify with your IT person that these settings are correct.• If necessary, make the required modifications and reboot the sensor• Press the Status button on the same page, and go to the Ethernet I/O Status page:• On the PC attached to your LAN, open the Command window. To do this, press Start > Run, and then type in cmd and press the OKbutton.• A command window will be displayed:iVu Plus BCR User's Manual142 www.bannerengineering.com - tel: 763-544-3164 Rev. B
