and the iVu Emulator is installed in the default location on the PC, copy the file :\BANNER\myName\CONFIG.CFG to C:\Program Files\Banner Engineering\iVu Series.5. Launch the iVuEmulator.exe program.6. Go to the Information screen (Main Menu > System > Information).7. Click the white box next to the Device Name label, and enter the desired Device Name.8. Click the Back button on the lower-left corner of the screen to save the Device Name.9. Close the Emulator program and the Device Name is saved to the CONFIG.CFG file.10. If you are running the Emulator on the PC, copy the CONFIG.CFG file back to the original folder on the USB flashdrive—:\BANNER\ (for example :\BANNER\myName).NOTE: The device looks in the original folder (for example, myName) for the CONFIG.CFG file.11. Remove the USB flash drive from the PC, and connect it to the device.12. Restore the configuration to the device.a. Go to Main Menu > System > Configuration > Load from USB.b. Select the Configuration to restore.c. Click the Load button to start the restore device configuration.NOTE: After the new device name is restored in the device, all files saved to USB flashdrive will now reside in the folder corresponding to the new device name.d. Reboot the device when the restore is complete.NOTE: If a Device Configuration from one device is loaded onto another device, the Device Name fromthe Device Configuration will not be stored in the device.11.3 How to Reset the Sensor PasswordIf you forget the password for your sensor, you can remove the current password using a reset key that is generated bythe Password Reset Utility, which is located on the Product CD. The following steps will guide you through the specificsteps to reset the password:1. On your iVu Series sensor, click the Forgot? button located on the bottom of the Enter Current Passwordscreen.2. Write down the 6-digit Device Key.3. On a Windows PC, insert the iVu product CD into the CD ROM drive.4. From the product CD menu (started upon inserting the CD), launch the Password Reset Utility.5. Enter the Device Key into the text box in the Utility—identified as Step 1 in the Password Reset Utility.6. Click the Generate Reset Key button.7. Write down the four-digit Password Reset Key—identified as Step 2 in the Password Reset Utility.8. On the iVu Series sensor, check the Next button on the Password Reset screen.9. Enter the 4-digit reset key on the Enter Reset Key screen.10. Click Apply.The password is now cleared.11.4 How to Use Bitmap Image Files with the iVu EmulatorYou can use bitmap (.bmp) image files with the iVu Emulator for developing and simulating iVu inspections. The iVuEmulator only accepts image files in .bmp format. If you have other image file formats, use an image viewer/editorprogram, such as PhotoShop, Gimp, or Paint, to convert the files to 8-bit grayscale .bmp format.NOTE: Images smaller than 640 × 480 are black-filled starting in the upper-right. Images larger than640 × 480 are cropped starting in the upper-left.1. Copy the .bmp files into the InspLog folder in the iVu Emulator install folder.For example, copy .bmp files into the C:\Program Files\Banner Engineering\iVu Series\InsLog folder.NOTE: Remove any existing .bmp or Log files in that folder to avoid confusion because the iVuEmulator automatically runs all .bmp/Log files sequentially according to filename.2. Launch the iVu Emulator program.iVu Plus TG Gen2 Image Sensorwww.bannerengineering.com - Tel: 763.544.3164 201
