6. Advanced configurationBarco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004 ________________________________________________________________________ 6-226.2.5 X server parametersIf you want to make changes to the graphical user interface X.11, which are not supported by the configurationtools introduced in section 3.4.2 X.11 configuration, you can manipulate the appearance and the properties of X.11with a large number of options.On A RGUS there are manual pages about the Xserver available. For reading these man pages enter manXserver in the command line:# man XserverAdditional options are listed in the table below:-no_cursor_on_video The cursor becomes invisible, as long as it is moved over videos.-ddc_all DDC detection is asked for every graphic channel. Each graphic channelneeds up to 6 seconds for detection. Therefore this should not be usedas a standard, see section 4.8.2 DDC utility.-no_ddc DDC detection is not done at all.Table 6-12The desired options must be entered manually each in a single line in the file:/etc/MMTconfig/MMTServerConfigX Server parameters that shall not be changed at a new run of the script EOSconfig can be entered between thetwo lines:# BeginSection Private# EndSectionThe file MMTServerConfig contains already lines inserted automatically by the configurationscript. Do not change these entries manually.
