12. Image Projection after Powering Up12. IMAGE PROJECTION AFTER POWERING UPOverview• Image Projection Using the Jog Dial on Cine VERSUM Master• Image Projection Using the Remote Control• Lamp Mode Set Up for Cine VERSUM 120 OnlyPicture display can be started up using the selection wheel on the Cine VERSUM Master or using its RemoteControl.12.1 Image Projection Using the Jog Dial on Cine VERSUM MasterHow starting the image projection1. Press the jog dial on the Cine VERSUM Master (On Cine VERSUM Master, page 27).Menu on graphical display changes as follows: (menu 12-1)2. Place the arrow, by rotating the jog dial, in front of the item ’Power Up’ (Always pointed at start up).3. Press the jog dial to confirm.The Cine VERSUM Master starts up, indicated by the message ’Power up’ in the display. A few dots appear successively,indicating the start up period, to disappear after started up. (menu 12-2)The Cine VERSUM Master starts on its turn image projection of the source, displayed when powering down the system, on theactive linked displays. The file of the selected source is added to the menu (left-bottom). (menu 12-3)CineVERSUM Master >POWER UPECONOMICCineVERSUM _________Menu 12-1Message >POWER UP* * * *CineVERSUM _________Menu 12-2CineVERSUM >To enter the menuPress the buttonor use the RCU7 xga75_gs.c03 _________Menu 12-312.2 Image Projection Using the Remote ControlWay of starting image projectionDifferent keys on the remote control can be used for starting image projection. Make sure that the Remote control suits the addressof the Cine VERSUM Master or uses the common address.• (A) Standby key: last selected source re-selected.• (B) Source selection key: direct access to the desired source.• (C) ADJ (Adjust) and ENTER key: last selected source re-selected.How starting the image projection(Case A & B)1. Press the standby key or a valid source selection key (On InfraRed Remote Control, page 30). The Cine VERSUM Master startsup, indicated by the message ’Power up’ in the display (menu 12-2).The Cine VERSUM Master starts operation mode and starts on its turn image projection on the active linked displays. In case ofpressing the standby key, the displayed image is the selected video source when powering down the system before. The file ofthe selected source is added to the menu (left-bottom)(menu 12-3).R5976468 CINE VERSUM SYSTEM 03112003 81
