13. Projection Stop (Standby or Economic Standby mode)13.2 Projection Stop Using the Remote ControlOverview• Direct System Shutdown (standby)• System Shutdown (standby) via screen menu13.2.1 Direct System Shutdown (standby)The On Screen menus on the Cine VERSUM 50, Cine VERSUM 80 and Cine VERSUM 120are with respect tocontent identic. Nevertheless, some items are specific for a display and are therefore grayed out if not ap-plicable for that specific display. Make sure that the Remote control suits the address of the Cine VERSUMMaster or uses the common address.How to stop image projection1. Point the front of the Remote Control (to the IR receiver of the Cine VERSUM Master, Cine VERSUM 80, Cine VERSUM 50, CineVERSUM 120 or the projection screen. The latter reflects the signal from the Remote Control. However, the effective distanceof the signal may differ due to the screen material.2. Press for a few seconds the standby key on the Remote control (On InfraRed Remote Control, page 30).On the screen appears a message, indicating the start of the power down process.After a few seconds, the Cine VERSUM Master goes into standby mode and switches on its turn the active linked displays intothe standby mode (disabling image projection). (menu 13-6)MESSAGEPOWER DOWNMenu 13-613.2.2 System Shutdown (standby) via screen menuHow to stop image projection1. Point the front of the Remote Control (to the IR receiver of the Cine VERSUM Master, Cine VERSUM 80, Cine VERSUM 50, CineVERSUM 120 or the projection screen. The latter reflects the signal from the Remote Control. However, the effective distanceof the signal may differ due to the screen material.2. Press the ’ADJ’ or ’ENTER’ key on the Remote Control (On InfraRed Remote Control, page 30).On the screen appears the main menu. (menu 13-7)3. Scroll through the items, using the arrow keys ↑ or ↓, until item ’Shutdown’ is highlighted (menu 13-7).4. Press ENTER to confirm.On the screen appears a message, indicating the start of the power down process.After a few seconds, the Cine VERSUM Master goes into standby mode and switches on its turn the active linked displays intothe standby mode (disabling image projection). (menu 13-8)Cine VERSUM SystemImage SettingsAdvanced SettingsInstallationService1 NO MODULE2 NO MODULE3 VIDEO [VIDEO]4 NO MODULE5 NO MODULE6 NO MODULE7 RGB-YUV [RGB]8 NO MODULEShutdownBackMenu 13-7MESSAGEPOWER DOWNMenu 13-886 R5976468 CINE VERSUM SYSTEM 03112003
