Ethernet Full Duplex Configuration Screen2E42-27/2E42-27R/2E43-27/2E43-27R User’s Guide5-41SET ALL PORTS (Toggle)All ports (1 through 24) can be set at once to either STANDARD orFULL from this field. To set ports, refer to Section 5.11.1.[1-12] or [13-24] (Navigation Key)When the Full Duplex Configuration screen displays, the currentoperation mode and status information are displayed for the first 12 ports.This field allows the user to step to the second screen for the same type ofinformation for ports 13 through 24. While on the second screen, the usercan navigate back to the first screen by highlighting the [1-12] field andpressing ENTER. The user can change the Operation Mode fields while ineither the first or second screen.5.11.1 Setting the Operation ModeThe Operational Mode may be set to Standard Ethernet or Full Duplexeither one port at a time or all at once. The following steps describesetting the port Operational Mode for individual ports followed by stepsto set the Operational Mode for all ports.To set the Operational Mode for individual ports, proceed as follows:1. Use the arrow keys to highlight the Operation Mode field adjacent tothe number of the port(s) that you plan to change.2. Press the SPACE bar until the appropriate mode, FULL DUPLEX orSTANDARD ENET displays in the field.3. Use the arrow keys to highlight the SAVE command on the bottomline of the screen.4. Press ENTER. The message “SAVED OK” displays.NOTEThe Operation Mode for the first 12 ports can be changed onthe first screen. To display the Operation Mode for Ports 13through 24, use the arrow keys to highlight the Ports [13-24]field and press ENTER. To again display the Operation Modefor Ports 1 through 12, use the arrow keys to highlight the Ports[1-12] field and press ENTER.
