Chapter 5: Local Management5-746H122-16 User’s GuideCurrent Switch Utilization (Read-only)Shows how much (percentage of capacity) the 6H122-16 is currentlybeing used.Peak Switch Utilization (Read-only)Shows the peak percentage of maximum switching capacity, since lastreset.Reset Peak Switch Utilization (Toggle)Allows the user to reset the Peak Switch Utilization field. The switch maybe set to either YES or NO as described in Section 5.21.1. YES resets thePeak Switch Utilization field to the current system traffic.5.21.1 Setting the Reset Peak UtilizationTo reset the Reset Peak Utilization field counter, proceed as follows:1. Use the arrow keys to highlight the Peak Switch Utilization field.2. Press the SPACE bar to select YES.3. Use the arrows keys to highlight the SAVE command at the bottom ofthe screen.4. Press ENTER. The message “SAVED OK” is displayed, and the ResetPeak Utilization counter is reset to zero.5.22 FLASH DOWNLOAD SCREENThe Flash Download screen, shown in Figure 5-31, allows the user toclear the information stored in the 6H122-16 FLASH memory anddownload a new image file from a TFTP server.Before downloading a new image to the module, load the image onto thenetwork TFTP server.NOTEThe user may also force a download by changing the positionof Switch 6 located inside the module. Refer to Section B.2 fordetails.NOTEFor information on how to set up a workstation as a TFTPserver, refer to the specific workstation documentation.
