Chapter 5: Local Management5-826H122-16 User’s Guide7. Use the arrow keys to highlight the Status field.8. Use the SPACE bar to select either the ADD or DEL (delete) option.Press ENTER. This adds or deletes the port selections made in steps 2and 4 and also updates the screen Source Port and Destination Port list.9. Use the arrow keys to highlight SAVE at the bottom of the screen.Press ENTER. The message “SAVED OK” is displayed.5.24 BROADCAST SUPPRESSION SCREENThe Broadcast Suppression screen, Figure 5-33, allows the user to set adesired limit of receive broadcast frames that are switched out to the otherports.To access the Broadcast Suppression screen from the Module SpecificConfiguration screen, use the arrow keys to highlight the BROADCASTSUPPRESSION menu item and press ENTER. The BroadcastSuppression screen displays.NOTEIf more than one port is to be redirected, repeat steps 1 through8 for each additional setting, then go to step 9 to save all thenew settings at once.NOTEThe Broadcast Suppression screen may not be available if theoperational mode of the module has been set to SECUREFAST VLAN. Refer to your Release Notes to see whatoperational modes support Broadcast Suppression. Refer toSection 5.15.9 for instructions on configuring the operationalmode of the module.Any broadcast frames received above the desired threshold willbe dropped.
