Chapter 5: Local Management5-486H122-16 User’s Guide3. Press ENTER to set the system calendar to the date in the input field.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the date entered is a valid format, the Event Message Line at the top ofthe screen displays “SAVED OK”. If the entry is not valid, LocalManagement does not alter the current value, but it does refresh theModule Date field with the previous value.5.15.6 Setting the Module TimeTo set the module clock, perform the following steps:1. Use the arrow keys to highlight the Module Time field.2. Enter the time in 24-hour format: HH:MM:SS3. Press ENTER to set the system clock to the time in the input field.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is a valid format, the Event Message Line at the top ofthe screen displays “SAVED OK”. If the entry is not valid, LocalManagement does not alter the current value and refreshes the ModuleTime field with the previous value.NOTEIf the 6C105 chassis has been assigned a chassis time, it is notnecessary to assign a module time to the 6H122-16. Allinstalled modules recognize the chassis time of the 6C105.NOTEWhen entering the time in the system time field, separatorsbetween hours, minutes, and seconds do not need to be addedas long as each entry uses two numeric characters. Forexample, to set the time to 6:45 A.M., type “064500” in theModule Time field.
