Cabletron Systems 9A600 Configuration Manual

Also see for 9A600: Hardware and installation guide

Contents

Cabletron Systems 9A600 Configuration Manual Manual pdf 125 page image

9A656-04 and 9A600 Configuration Guide4-11Configuring IISP4.5 CONFIGURING IISPThe following subsections provide an example of configuring IISP.The steps required to configure the IISP interface are broken down as follows:• Signalling Configuration• Step 1: Setting the Signalling Stack Type (Section 4.5.1.1)• Step 2: Setting the Signalling Side (Section 4.5.1.2)• Step 3: Create and Configure a Reachable Address (Section 4.6)NOTE This example describes how to set one side (the user side) of the IISP interface. Forthe interface to become fully operational, the same configuration must be take placeon the switch to which this switch will connect, the only difference being the otherswitch’s interface should be set up as the network side.