Chapter 2: Basic System Configuration2-509A656-04 and 9A600 Configuration Guide2.23.1 LAN Emulation Client Administration Screen FieldsThe following list explains each of the LAN Emulation Client Administration Screen fieldsand commands:LEC Index (Read-only)This field is used to identify this LEC in the ATM Forum’s LEC MIB. This value is provideddynamically and is not modifiable by the user.LEC Status (Toggle)This field displays the current status of this LEC. This field toggles between “active” or “NotIn Service”.Configure ELAN (Toggle)This field is used to specify if the LEC is created manually by user, or automatically by theSmartSwitch 9500. This field toggles between Automatic and Manual. For instructions onhow to configure the LEC automatically and manually, refer to Section 2.23.2 andSection 2.23.3.ELAN Name (Modifiable)This field is used to provide a user-defined ELAN for this LEC to join. This field is modifiablewhen the LEC is configured in both automatic and manual mode.MAX MTU Size (Read-Only)This field displays 1516. This is the only MAX MTU size allowed for the management LEC.LAN Type (Read-Only)This field displays the type of ELAN that this LEC joins. This field is read-only and displays802.3, which is the only type of ELAN currently supported.NOTE If this field is left blank, the LEC will attempt to join the default ELAN, as defined bythe wellknown LECS.If the LEC is created manually, the name entered in the ELAN Name field is theONLY ELAN the LEC will join. The LEC will not take another ELAN name from theLES.NOTE The LES ATM Address field does not display if the LEC is configured automatically.Instead, the field reads LECS ATM Address. If the LEC is configured automatically,it is not possible to enter the LES ATM Address, as the SmartSwitch 9500 learnsthe address dynamically from the LECS.
