Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual

Also see for CyberSWITCH 5500: User guide Manual

Contents

Central Site Remote Access Switch 23C ONNECTIVITYConnecting a Central Site Product to a Workgroup Product via PPPc. Under AppleTalk Port Information, configure a WAN UnNumbered port:• Select the WAN UnNumbered port type.d. Under AppleTalk Static Routes, configure a static route to Remote:• Enter Extended for Remote’s network type (the default).• Enter 45-50 as the destination network range (Remote’s network range).• Enter 0.0 as the next hop (it’s over an unnumbered link).• Enter Remote as the next hop’s device name.• Enter 2 as the number of hops for this route.• Enter Remote.Engineering as Remote’s default zone name.• Enter Remote.Marketing as Remote’s second zone name.4. Under Security, select System Options and Information, then under System Information:a. Set your System Name (Central). This matches up with Central device informationconfigured on Remote.b. Set your System Secret (Central_S). This matches up with Central device informationconfigured on Remote.C ONFIGURATION FOR S ITE "REMOTE"The configuration on Remote to allow AppleTalk Routing to Central is as follows:1. Perform initial configuration steps.2. Under Security, select Device Level Databases, select On-node Device Entries, then add a devicewhere the Device Name (Central) must match the system name on Central. When you add thedevice you must then enter the following information:a. Under ISDN Information select ISDN Line Protocol, then select PPP.b. Optional: If you wish to dial out to Central, under ISDN Information you must enter a dialout number and a base data rate (64Kb).c. Under Authentication you must:• Change CHAP Secret so that it matches Central’s System secret (Central_S).• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).d. Under AppleTalk Information you must:• Enter 0.0 for the AppleTalk address.• Enable AppleTalk Routing.• Enable making calls for AppleTalk data.3. Under Options, select AppleTalk Routing, then:a. Enable AppleTalk routing.b. Under AppleTalk Port Information, configure a LAN port:• Select the LAN port type.• Enter lanport1 for the port name.• Enter 1 for the LAN port number.• Select the Extended network type (the default).• Enter 45-50 for the network range.• Accept the default of none for the suggested AppleTalk address.• Enter Remote.Engineering as the port’s default zone name.• Enter Remote.Marketing as the second zone name.