Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual

Also see for CyberSWITCH 5500: User guide Manual

Contents

QUICK START28 CyberSWITCHIPX ROUTER TO BRIDGE CONFIGURATIONUsing the IPX WAN Remote LAN feature provides easy set up for the network administrator,especially if there are multiple remote sites.C ONFIGURATION FOR S ITE “CENTRAL”The configuration on Central to allow IPX Routing to Remote using PPP is as follows:1. Perform initial configuration steps.2. Under Options, select IPX Routing, then:a. Enable IPX Routing.b. Under IPX Internal Network Number enter the following value: 123456.c. Under IPX Interfaces add a LAN Interface and a hexadecimal IPX Network Number(0000BEEF).d. Under IPX Interfaces add a WAN (Remote LAN) Interface and a hexadecimal IPX NetworkNumber (0000BEEF).3. Under Security, select System Options and Information, then under System Information:a. Set your System Name (Central). This matches up with Central device informationconfigured on Remote.b. Set your System Secret (Central_S). This matches up with Central device informationconfigured on Remote.6. Under Security, select Device Level Databases, select On-node Device Entries, then add a devicewhere the Device Name (Remote) must match the system name on Remote. When you add thedevice you must then enter the following information:a. Under ISDN Information select ISDN Line Protocol, then select PPP.b. Under Authentication you must:• Change CHAP Secret so that it matches Remote’s System secret (Remote_S).• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).c. Under Bridge Information you must make sure that Bridging is enabledISDNNetwork #0000BEEFFILESER1Node # 0409A0111111IN # 432109*CSX5500Phone # 13135551111IN # 123456*CSX100Phone # 13135552222* IN # = Internal Network Number"Central" "Remote" C A B L E T R O N S Y S T E M S